Software programmable using our ECP (Event
Control Programmer) Software, a windows based software designed specifically to
program our family of event control timers. Please note: The PECT does not ship with
software, see below to download or order
the software on disk.
Stand alone operation – once the PECT is programmed
by the software the unit is fully self-contained. Applying power to the
device after programming will immediately start its event cycle when it
receives a signal from the sensor. The PECT may also be operated from
the PC to test its timing cycle.
Easy hook up using modular telephone cable. Designed
to work with our Miniature PIR
Sensors, but can be easily interfaced to
a switch or other 5 VDC input device. (Sensor cables not included, but
the cable
assemblies may be purchased here).
When used as a complete system with the 8
Channel Serial Relay Board, eight 10 Amp @ 250VAC/28VDC SPDT Relay outputs
are controlled by the PECT as shown in Figure 1.
Two Board designs available:
1 - With enclosure
and external wall transformer
2 - No enclosure with an internal (on board) power
transformer
for use inside a customers
enclosure, or where multiple wall
transformers would be impractical.
(120 VAC input to the board.)
Additional Feature:
The 8 Channel PECT is capable of operating in a
multiple board configuration. Up to eight separate 8 Channel
Programmable Event Control Timers may be connected in a daisy chain
topology (64 channel inputs) into one PC serial Port. This allows
you to connect 64 sensors (or other inputs) to one serial port on the
PC. In this configuration the Personal Computer controls the
inputs instead of the built-in timer functions. This allows you to
connect serial output relay boards to the second serial port and control
a large system from the PC.
Data
Sheet & Programming Software:
8
Channel PECT Interface Datasheet (Available soon)
Event
Control Programmer Software
Download software here or order on disk below
