Features
The
first Software Programmable Event Control Timer (ECT), a perfect
choice for any timed event, can be used as a cycle timer, repeat
timer, or for use in any application where a general purpose
timer is required. Many of our timers are used in haunted
attractions to activate special effects.
Dual Channel Programmable Event Control
Timer with three events (delay event, event duration, and
recycle delay) with up to 240 seconds (four minutes) per
individual event activated by our PIR sensors or other input
device.
Software programmable using our ECP Software
(Event Control Programmer) a windows based software designed
specifically to program our family of event controllers. Please
note: The PECT does not ship with software, see below to
download or order the software on disk.
Stand alone operation – once the PECT is
programmed by the software the unit is fully self-contained.
Applying power to the device after programming will immediately
start its event cycle when it receives a signal from the sensor.
The PECT may also be operated from the PC to test its timing
cycle.
Easy hook up using modular telephone cable.
Designed to work with our Miniature
PIR Sensors, but can be easily interfaced to a switch
or other 5 VDC input device. (Sensor cables not included, but
you can purchase the cable
assemblies here).
Dual channel 10 Amp @ 250VAC/28VDC SPDT Relay
output.
Two Board designs available:
1 - With enclosure and external wall transformer
2 - Without enclosure with an internal (on board) power
transformer
for use inside a customers
enclosure, or where multiple wall
transformers would be
impractical. (120 VAC input to the board.)
Data
Sheet & Programming Software:
Single/Dual
Channel Datasheet
(136KB)
Download software here or order on
disk below.
Event
Control Programmer Software
